Enamel PF-266: characteristics and application

As a rule, when repairing in houses or apartments with wooden floors, paint is used. This coating has many valuable benefits. First of all, it makes the floor surface glossy, shiny and even.

One of the best options for the design of floor surfaces is alkyd enamel PF-266M. This product is characterized by high quality of the formed coating, good resistance to any mechanical and chemical effects, as well as excellent wear resistance.

Paint PF-266M is made on the basis of alkyd varnish. Due to the inclusion in the enamel of various additives, it has protective and decorative properties. Since the coating PF has high technical characteristics, It perfectly tolerates exposure to certain solvents and detergents.. Also, the composition is easy and quick to apply.

The color range of enamel is presented in several tones: golden brown, yellow brown and red brown.. Since the variety of colors is small, it significantly limits the scope of enamel. However, the advantage of the material is that the paint consumption at work is small.

Immediately after covering the floor with this composition, you will notice that the surface will become smoother and more even. Full drying of enamel at room temperature occurs about a day after staining.

Technical characteristics of PF-266 enamel:

• high abrasion resistance;
• ability to withstand very low and very high temperatures;
• good water resistance;
• the ability to carry a large mechanical impact;
• the viscosity of the consistency at room temperature is in the range from 60 to 90;
• the level of the periter does not exceed more than 50 percent;
• not dried layer of composition covers the basis of the calculation of 70 g / m²;
• Flexural flexibility is 1 mm.

This tool is used for painting various wood, concrete or metal surfaces. It is widely used in domestic and industrial premises. Enamel PF-266M is suitable for use only inside houses and buildings. To put this structure is allowed both on an unpainted surface, and on the painted.

The main quality of such enamel is to protect the surface from mechanical impact, therefore Usually the tool is used in those premises in which residents are quite often. Also, this material is bought by some construction companies that carry out repair work in various premises intended for public use.

Before applying the composition it is necessary to carry out certain preparatory work. It is worth preparing in advance not only the surface, but also the paint itself.. To begin with, open the can and remove the film formed on the surface of the composition. Then mix well the contents of the jar with a special construction drill until a homogeneous mass is formed.

If the composition has a too thick consistency, then dilute it with a solvent to the working viscosity. For example, it may be white spirit, turpentine or solvent PC2.

To prepare the surface for painting, it is important to ensure that it is thoroughly cleaned of dirt and dust.

After the preliminary preparation of the enamel PF-266M and the surface being trimmed, painting can be started. For work usually use a special sprayer, not too a pile construction roller or paint brush. Usually enamel is applied to the surface in two or three layers. in order for the coating to become more reliable. It should be borne in mind that in this case the drying time increases slightly. After completing the job, tidy up all the tools used with a solvent.

During dyeing, it is recommended to follow the safety regulations, wear gloves and a respirator. After finishing work, be sure to air the room., since the coating is toxic. Do not allow moisture or direct sunlight to enter the room.. In the case of enamel on open areas of the body, they should be washed with warm water and soap, and the remaining paint removed with vegetable oil.

The following video presents an overview of enamel from the manufacturer Farbex.